System Description

BDA M410 TA03 / 2019-09 (GB)

STRUCTURE OF THE KEYPAD TA03

You can cancel any operaon at any me by pressing the cancel buon

. When the cancel buon is pressed,

there is one short red ashing. Any input already made is deleted.

During operaon, make sure that each key input is acknowledged by a light signal at the LED display! If a light signal

does not appear, the key input was not accepted.

The opcal signals are dierenated in colour and in duraon as shown below:

Note:

If no further key input is made during the entry of a code or during a programming operaon, the already made

entries will be discarded aer 30 seconds. The old code remains valid.

Aer the third entry of an invalid code, the opon to enter a code is blocked for 30 seconds. The LED display ashes

red for nine mes. When a key is pressed during these 30 seconds, the LED display ashes red once.

Numbers 0-9

Cancel Enter

LED display

Short ashing

Long ashing

Connuous light

BOLT END POSITION SCAN FUNCTION

The locking system also has a bolt end posion scan funcon. If, during the locking process, the bolt does not reach

its end posion, the LED display ashes red for four mes. The lock is not locked. Check the correct mounng posi-

on of the lock, the bolt protector and the striker plate.

Trip point for removing

the cover for emergency

power supply