User manual

Control Panel 9
C ONTROL P ANEL
You set the address and personalities, read out data, and execute service utilities from the control panel.
Settings can also be changed remotely via the serial link with the Martin MP-2 uploader.
There are four small symbols that can appear in the control panel display:
Menu navigation
See also the control menu table starting on page 34.
The DMX address and any error messages are displayed after the fixture resets. To enter the menu, press
[menu]. Use the [up] and [down] keys to move within the menu. To select a function or submenu, press
[enter]. To escape a function or menu, press [menu].
Address selection
The CX-10 requires 10 channels for DMX control. The address, also known as the start channel, is the first
channel used to receive instructions from the controller. For independent control, each fixture must be
assigned its own address and non-overlapping control channels. Two CX-10s can share the same address
Power is on and the fixture is ready.
The fixture is writing to memory. Do not power off the fixture while this symbol is
lit.
The fixture is receiving DMX.
Error. See “Error messages” on page 37 and “Troubleshooting” on page 38.
AddR
dMXL UTIL
Address/
Messages
STCO
SHUT
....
EFSP
AdJ
PCbT
UPLd
TSEQPERS dFSE INFO
SCUT
dISP
dINT
dLOF
ALON
FACT
CAL
dFOF
TIME
HRS
L HR
L ST
VERdRES
RST
L ON
LoFF
EFCT
SHUT
dIM
COL
FOC
RATE
qUAL
MAN
RUN
WHEL