Manual

ManualsBrandsMartin Universal Design ManualsFurnitureU-DS6000P Ridgeline Table

Assembly Instructions

U-DS6000P

IMPORTANT

If you have difﬁculty assembling your U-DS6000P Ridgeline Table

or need customer service assistance. Please call:

Martin Universal Design, Inc. Customer Service Hot Line at 1-313-895-0700.

If you need additional parts, it is not necessary to contact your dealer,

our Customer Service Rep. will forward them to you immediately

Martin Universal Design, Inc. • Detroit, MI 48208 USA

Tel: 313-895-0700 • E-mail: custservMUD@aol.com

www.MartinUniversalDesign.com

Since 1853

November 09, RPI

Ridgeline

Summary of content (5 pages)

PAGE 1
Ridgeline Assembly Instructions U-DS6000P IMPORTANT If you have difﬁculty assembling your U-DS6000P Ridgeline Table or need customer service assistance. Please call: Martin Universal Design, Inc. Customer Service Hot Line at 1-313-895-0700. If you need additional parts, it is not necessary to contact your dealer, our Customer Service Rep. will forward them to you immediately. Since 1853 Martin Universal Design, Inc. • Detroit, MI 48208 USA Tel: 313-895-0700 • E-mail: custservMUD@aol.com www.
PAGE 2
Ridgeline Since 1853 Hardware Parts List A B 2PCS 4PCS Side Support E C 2PCS 2PCS Panel Height Adj. Tube w/ hole Floor Leveler F D G H 1PC 2PCS 2PCS 14 PCS Top Height Adj.
PAGE 3
Since 1853 Ridgeline NOTE: We reccommend the The Assembly of this table to be performed with two adult people. Assembly FIG 1 A STEP 1 B Begin assembly of the Ridgeline table by taking the side support (part A) and attaching the floor levelers (part B) to the side supports. See Fig 1 B A B B STEP 2 FIG 2 C Continue by attaching the panel (part C) to (part A) the side support, using 6 each M6x12mm bolts (part J).
PAGE 4
Since 1853 Ridgeline STEP 4 Attaching Height Adjustment Tubes. Assembly FIG 4 Dx2 Fx2 To attach the height adjustment tubes (part D + part F), use 4 each (part I) knob. Leave a 12” gap from the top of the side supports, and secure the tubes in place by tightening the tubes with the knobs. See Fig 4 Ix4 HX8 STEP 5A FIG 5 Attach (part Q), metal guide, by using 6 each 4x14mm screws (part H). See Fig 5 HX6 STEP 5B Attach (part G), tilt mechanism, by using 8 each 4x14mm screws (part H).
PAGE 5
Since 1853 Ridgeline STEP 6 Attach Base to Top Attaching Tilt Mechanism to Height Adjustment Tube. To attach the tilt mechanism (part G) to the height adjustment tube, you will need the following parts 1 each (part M) 8x50mm bolt, 2 each (part L) washer, 1 each (part K) washer, 1 each (part N) nut. Follow the diagram in Figure 6 to attach the parts in the correct order.