User manual

12 Controller set-up
C ONTROLLER SET - UP 4
FIXTURE SET-UP
1 Press and hold EDIT for 3 seconds.
2 If the PIN-code function is enabled (see “Administrative functions” on page 22), you
will be prompted to enter the PIN code (factory set as “221174”). Use the fixture
buttons to select numbers. Press ENTER.
3 Press FIXTURE so that the red indicator is lit.
4 Select a fixture to be set-up (and any other fixture of the same type) using the
numbered buttons, 1-12. You can select a range of fixtures by pressing and holding
the first and last fixture buttons.
5 Press ENTER.
6 Specify the pan channel by moving the fader that corresponds to the pan channel of
the luminaire (refer to the DMX protocol in the luminaire’s user manual to find this),
and then press ENTER.
7 Specify the tilt channel by moving the fader that corresponds to the tilt channel of the
luminaire (refer to the DMX protocol in the luminaire’s user manual to find this), and
then press ENTER.