User manual

14 Controller set-up
SMOKE SET-UP
The Freekie can control one or more smoke devices that have a DMX control
address of 157. During a show you can activate smoke effects using the SMOKE
button. To configure smoke effects:
1 Press and hold EDIT for 3 seconds.
2 If the PIN-code function is enabled (see “Administrative functions” on page 22), you
will be prompted to enter the PIN code (factory set as “221174”). Use the fixture
buttons to select numbers. Press ENTER.
3 Press SMOKE.
4 Set the smoke active scene (where the fixture emits smoke) using the appropriate
faders (representing channels 1-12) and then press ENTER.
5 Set the inactive smoke scene (where the fixture does not emit smoke, fog, or haze)
using the appropriate faders (representing channels 1-12) and then press ENTER.
6 Press EDIT to leave fixture set up mode.
FOLLOW-SPOT SET-UP
The Freekie can use an individual fixture as a follow-spot device that can be
controlled independently using the joystick during playback of a show. To
configure the follow-spot scene:
1 Press and hold EDIT for 3 seconds.
2 If the PIN-code function is enabled (see “Administrative functions” on page 22), you
will be prompted to enter the PIN code (factory set as “221174”). Use the fixture
buttons to select numbers. Press ENTER.
3 Press SPOT.
4 Select the follow-spot fixture using the numbered buttons, 1-12.
5 Set the follow-spot scene effect on the fixture using the faders. For example, the color
might be white.
6 Set the fade time into the spot effect using the FADE TIME/PITCH fader.
7 Press ENTER.
8 Press EDIT to leave fixture set up mode.