User manual

Playback

LAYBACK

This section describes the built-in options for executing shows.

RUNNING A SHOW

To select and run a show:

1 Select the appropriate bank with the < or > buttons. Note that you can change banks

whenever the SHOW button is toggled off (when the indicator is not lit).

2 Press SHOW.

3 Select a show using one of the numbered buttons (1-12). The show will start to run

immediately, and will run in a loop. You can select a range of shows by pressing and

holding the first and last show number buttons. The selected shows will run in a loop

when executed.

There are three ways to execute shows:

• Execution using programmed scene times, or

• Music trigger execution to the beat of the music, or

• MIDI show execution

Execution using programmed scene times

Shows will run using their programmed scene times when the FADE

TIME/PITCH fader is in the middle position.

Music trigger execution

Music triggered scene changes are enabled by the built-in microphone, or from

audio signals from an external microphone. In Control-By-Audio mode the Freekie

will change scenes to the beat of the music (wait times in scenes will not be used).

To activate music trigger execution set the FADE TIME/PITCH fader to the zero

position. CONTROL BY AUDIO will appear in the display.

MIDI triggering

Some differences in MIDI triggering capability exist between software versions. To

find out which software version your Freekie is running, switch on the Freekie. The

software version number appears in the display during startup.