User manual

20 Playback
2 Select a fixture, or fixtures, using the numbered buttons (1 - 12).
3 Use the faders to override the programmed effects for those fixtures. For example, to
change the programmed mirror movement speed of one or more scanners during a
show, you would set the pan/tilt speed channel to the desired value. (The DMX value
does not change until the fader is moved.)
4 Normal program execution resumes when FIXTURE button is deactivated.
INTENSITY CONTROL
The master fader controls the intensity of all the fixtures.
BLACKOUT
In blackout mode, the Freekie blacks out all the fixtures by setting their dimmer
values to their minimum level (see “Fixture set-up” on page 12).
Press BLACKOUT to activate blackout mode, Press it again to reset the fixtures to
the current scene.
Blackout does not affect the follow-spot fixture if this has been activated (see
“Follow spot” on page 20).
DYNAMICALLY MODIFYING FADE TIMES
You can dynamically adjust the fade and wait times in a show up or down using the
FADE TIME/PITCH fader.
FOLLOW SPOT
Ensure that you have configured a follow-spot fixture and scene. See “Follow-spot
set-up” on page 14.
To use the follow-spot:
1 Press the SPOT button (the indicator will light up) during scene show playback. The
show will continue to be played normally with the exception of the follow-spot fixture.
2 Use the joystick to move the follow-spot effect. To use smaller movements press
FINE.
During the follow-spot scene the faders can be used to control the first 12 channels
of the follow-spot fixture.