User manual

DMX address setting

DMX

ADDRESS

SETTING

Each fixture connected to the serial link must have a DMX address, also known as a

start channel, which is the first channel the controller uses to send instructions to the

fixture. Fixtures of the same type that share the same address will mimic each

others behavior.

Freekie allows control of up to 12 fixtures or fixture groups. (A fixture group

comprises similar fixtures with the same DMX address.) The Freekie can control

the first 12 channels of each fixture, or group, and can activate smoke and strobe

fixtures. The Freekie assigns 12 channels to each fixture regardless of how many

channels it uses, therefore the DMX addresses have been pre-defined.

Assign the following addresses using the procedure that is required for each fixture

(refer to the user documentation for the fixture if you are in doubt as to the

procedure). The address is often set on the fixture using a DIP-switch, while others

use electronic address setting.

Freekie

fixture ID DMX address DIP switch setting

213

325

437