User's Manual

Safety Information 5
PROTECTION FROM ELECTRIC SHOCK
• Do not remove any cover from the fixture except as described under “Service and maintenance” on
page 13.
• Disconnect the fixture from AC power before servicing it and when it is not in use.
• Ensure that the fixture is electrically connected to ground (earth).
• Use only a source of AC power that complies with local building and electrical codes and has both
overload and ground-fault (earth-fault) protection.
• The cable used to connect the fixture to AC power must be 14 AWG or 1.5 mm
2
minimum conductor size
and heat-resistant to 90° C (194° F) minimum. It must have three conductors and an outer cable diameter
of 5 - 15 mm (0.2 - 0.6 in.). In the USA and Canada, the cable must be UL/CSA-recognized, hard usage,
type SJT or equivalent. In the EU, the cable must be type H07RN-F or equivalent.
• Before using the fixture, check that all power distribution equipment and cables are in perfect condition
and rated for the current requirements of all connected devices.
• Isolate the fixture from power immediately if the power plug or any seal, cover, cable, or other component
is damaged, defective, deformed, wet or showing signs of overheating. Do not reapply power until repairs
have been completed.
• Use only a Neutrik TRUE1 NAC3FX-W cable connector to connect to the power input socket.
• Do not expose the fixture to rain or moisture.
• The MAC Encore Performance contains components that are accessible and live at high voltage while the
fixture is connected to power and that remain under tension for 30 minutes after power is disconnected.
Only technicians who are authorized by Martin and who have the Martin service documentation for the
MAC Encore Performance are permitted to open the fixture.
• Refer any service operation not described in this manual or in the MAC Encore Performance User Guide
to Martin Service or an authorized Martin Service partner.
• The light source contained in this fixture may only be replaced by Martin Service or an authorized Martin
Service partner.
PROTECTION FROM BURNS AND FIRE
• The exterior of the fixture becomes hot during use. After 5 minutes of operation a surface temperature of
75° C (167° F) shall be expected. The maximum steady state surface temperature is also 75° C (167° F).
Avoid contact by persons and materials.
• Allow the fixture to cool for at least 30 minutes before handling.
• Keep all combustible materials (e.g. fabric, wood, paper) at least 0.2 m (8 in.) away from the fixture.
• Keep flammable materials well away from the fixture.
• Ensure that there is free and unobstructed airflow around the fixture.
• Provide a minimum clearance of 0.2 m (8 in.) around fans and air vents.
• Do not illuminate surfaces within 2.0 m (6.6 ft.) of the fixture.
• Do not expose the front glass to sunlight or any other strong light source from any angle. Lenses can
focus the sun's rays inside the fixture, creating a potential fire hazard.
• Do not attempt to bypass thermostatic switches or fuses.
• Do not operate the fixture if the ambient temperature (Ta) exceeds 40° C (104° F).
• Do not modify the fixture in any way not described in this manual or the fixture’s User Guide or install other
than genuine Martin parts. Do not stick filters, masks or other materials onto any lens or other optical
component. Use only accessories approved by Martin to mask or modify the light beam.
PROTECTION FROM EYE INJURY
• This fixture is a Risk Group 2 product according to EN 62471. It emits possibly hazardous optical
radiation. It falls into the Risk Group categories shown below according to EN 62471.
• Do not look directly into the fixture’s light output.
DO NOT RISK GROUP
2
RISK GROUP
1
0.2 m
(7.9 ins.)
16.5 m
(54.2 ft.)
18.6 m
(61.1 ft.)
EXPOSE
RISK GROUP
EXEMPT