User manual

6 MAC 250 Wash
• Check that power supply settings match the local AC power before use.
• Do not expose the fixture to rain or moisture.
• Refer any service operation not described in this manual to a qualified technician.
PROTECTION FROM UV RADIATION AND LAMP EXPLOSION
• Do not operate the fixture with missing or damaged covers, shields, lenses or ultraviolet screens.
• Allow the fixture to cool for at least 45 minutes before opening it or removing the lamp. Protect your hands
and eyes with gloves and safety glasses when handling lamps.
• Do not stare directly into the light. Never look at an exposed lamp while it is lit.
• Replace the lamp if it becomes thermally deformed, damaged, defective or worn out.
• Replace the lamp before usage exceeds the maximum service life.
PROTECTION FROM BURNS AND FIRE
Danger! Intense heat. Avoid contact by persons and materials.
The exterior of the fixture can get very hot – up to 160° C (320° F). Allow the fixture to cool
for at least 45 minutes before handling.
Prolonged exposure to an unshielded lamp can cause eye and skin burns.
• Never attempt to bypass the thermostatic switch or fuses. Always replace defective fuses with ones of the
specified type and rating.
• Keep all combustible materials (for example fabric, wood, paper) at least 0.1 meter (4 inches) away from
the fixture. Keep flammable materials well away from the fixture.
• Do not illuminate surfaces within 0.5 meters (20 inches) of the fixture.
• Provide a minimum clearance of 0.1 meters (4 inches) around fans and air vents.
• Never place filters or other materials over the lens.
• Do not modify the fixture or install other than genuine Martin parts.
• Do not operate the fixture if the ambient temperature (Ta) exceeds 40° C (104° F).
PROTECTION FROM INJURY DUE TO FALLS
• Do not lift or carry the fixture alone.
• When suspending the fixture, check that the structure can hold at least 10 times the weight of all installed
devices.
• Check that all external covers and rigging hardware are securely fastened and use an approved means of
secondary attachment such as a safety cable.
• Block access below the work area whenever installing or removing the fixture.