User manual

16 Optional accessories (Magnum 850 only)
To produce a timed burst of fog, press the FOG button briefly. To stop the timed
fog output early, press the FOG button briefly again.
Disabling timer mode
If you wish to simplify the remote control, you can disable the timer function. This
means that a short press on the FOG button will just produce a short burst of fog
and the timer will not be enabled.
1. Press the TIMER SET button once. The ON light flashes.
2. Turn the knob fully left to the “OFF” section.
3. Press the TIMER SET button again.
The zero times will be stored, disabling the timer. This will be remembered even
after the unit has been switched off. The ON and OFF lights remain off when the
timer is disabled.
To re-enable the timer function, store some non-zero times as described above.
Meaning of remote control lights
The four lights on the remote have the following functions. The red “HEAT” light
and the green “READY” light are also duplicated on the top of the machine itself.
HEAT+READY meaning
no lights Machine is not powered, or remote is not connected
heat
Machine is heating but is not yet up to operating
temperature
heat + ready
Machine is heating and has reached minimum operating
temperature. Fog output level may be reduced while
heating.
ready
Machine has finished heating and is at full operating
temperature
OFF+ON meaning
no lights Timer is disabled
both on Timer is programmed but not enabled
“OFF” lit Timer is running, currently in Off/Wait period
“ON” lit Timer is running, currently in On/Run period
“ON” flashing The timer “ON” time is currently being programmed
“ON” lit, “OFF”
flashing
The timer “OFF” time is currently being programmed