User manual

Troubleshooting 19
Troubleshooting
Problem Probable cause(s) Suggested remedy
Machine not at operating
temperature
Wait 10 to 15 minutes
Machine will not produce fog
when remote control Fog
button pressed
Machine not powered up
Ensure mains power switch
on and AC power is OK
Smoke output is weak Machine requires priming Prime machine (page 12)
Wet, greasy, non-uniform
smoke output, fluid drips or
spits from nozzles, or very
loud noise when firing
machine
Incompatible smoke fluid Use only approved fluid!
Mains fuse blown Replace fuse (page 18)
Machine appears dead
No power at AC cable inlet
Check power cable and
circuit breaker