User Manual

20 RUSH Wizard User Manual
Fixture setup
This section explains manual focus adjustment and the fixture settings and
utilities that the user has access to via the control panel.
Settings are retained when the fixture is powered off.
For a complete map of the control menu
structure, see ‘Control menus’ on page 23.
Focus
See illustration on right. You can adjust the
sharpness of the fixture’s projections by
turning the focus knob (arrowed).
Using the control menus
To access the control menus, press the MENU
button. Navigate the menu structure using the
ENTER, DOWN and UP buttons. Select any required menu option using the
ENTER button. To return to the previous level in the menu structure without
making a change, press the MENU button.
To exit the menus, press and hold the MENU button.
DMX addressing
The fixture can be controlled using signals sent by a DMX controller. The
DMX address, also known as the start channel, is the first channel used to
receive instructions from a DMX controller. Each DMX-controlled fixture must
have a DMX address set. If a fixture has its DMX address set to 1, for
example, then it uses channels 1 to 10. The next fixture on the DMX link can
have its DMX address set to 11, the next to 21 and so on until the 512
channels in one DMX universe are allocated.
For independent control, each fixture must be assigned its own control
channels. Two fixtures of the same type may share the same address, if
identical behavior is desired. Address sharing can be useful for diagnostic
purposes and symmetric control, particularly when combined with the inverse
pan and tilt options.
To set the fixture’s DMX address:
1. In the control panel, select DMX ADDRESS
and press ENTER.