User Manual

RUSH Wizard User Manual 21
2. Use the UP and DOWN buttons to select DMX ADDRESS and press
ENTER to confirm. The present address will blink on the display.
3. Use the UP and DOWN buttons to select a new address.
4. Once the address has been selected, press ENTER to set it (or press
MENU to exit without making a change).
Standalone operation
The fixture can run a standalone light show without needing a DMX signal. 6
different pre-programmed standalone shows are available. Shows can be
triggered automatically or by a music beat.
Show mode
To select which pre-programmed show a fixture runs in standalone mode:
1. Select SHOW MODE and press ENTER to confirm.
2. Use the DOWN and UP buttons to select SHOW 0 (random show) or
SHOW 1 to SHOW 6 (pre-programmed shows).
3. Press ENTER to set (or press MENU to exit without making a change).
Master/slave operation
Fixtures in standalone mode can be linked in a chain and set to master/slave
operation, where one master fixture running a standalone show controls
synchronized scene changes in slave fixtures.
You must set all the fixtures except one as slaves. If you allow more than one
fixture in a chain to act as master, you may cause damage that is not covered
by the product warranty.
To run fixtures in master/slave operation:
1. Link fixtures in a chain, using DMX cable to connect one fixture’s DMX
OUT socket to the next fixture’s DMX IN socket.
2. Set all fixtures to enter Master/Slave mode when they are not receiving a
DMX signal in the DMX STATE menu (see ‘Control menus’ on page 40).
3. Set the first fixture in the chain to run a standalone show using its SHOW
MODE menu (see ‘Show mode’ above). This fixture will now act as the
master.