User Manual

22 RUSH Wizard User Manual
4. On each of the other fixtures in the chain, select SLAVE MODE and press
ENTER. Use the UP and DOWN buttons to select SLAVE 1 (fixture runs
the same show as the master) or SLAVE 2 (fixture runs a show that is
synchronized with the master but has slight variations). Then press
ENTER to set (or press MENU to exit without making a change).
5. Make sure that the fixtures are not receiving a DMX signal.
When fixtures are correctly connected and set up in master/slave operation,
the Master status LED on the master fixture and the Slave status LED on
slave fixtures light constantly.
Split colors
The fixture can be set so that the color wheel shows split and full colors or
shows full colors only. To alter the split color setting:
1. Select SPLIT COLOR
and press ENTER.
2. Use the UP and DOWN buttons to select YES or NO and press ENTER to
confirm. The currently active mode will blink on the display.
3. Use the UP and DOWN buttons to select YES (split colors allowed) or NO
(full colors only).
4. Press ENTER to set (or press MENU to exit without making a change).
Sound activation (music trig)
The fixture’s built-in sound activation microphone can be used to trigger scene
changes with a music beat when the fixture is running a standalone show.
When sound activation is running, the Sound status LED on the control panel
flashes in synch with the music beat.
To set music trig sound activation:
1. Select SOUND MODE
and press ENTER to confirm.
2. Use the DOWN and UP buttons to select ON (sound activation enabled)
or
OFF (sound activation disabled).
3. Press ENTER to set (or press MENU to exit without making a change).
Sound activation microphone sensitivity
To adjust the sensitivity of the sound activation microphone:
1. Select SOUND SENSE and press ENTER to confirm.