User Manual

RUSH Wizard User Manual 23
2. Use the DOWN and UP buttons to change the microphone sensitivity
level from 0…100.
3. Press ENTER to set the level (or press MENU to exit without making a
change).
DMX state (behavior when DMX signal stops)
You can define the behavior of the fixture if it is powered on and the DMX
signal stops.
The fixture is set to Blackout by default.
To set fixture behavior if the DMX signal stops:
1. Select DMX STATE
and press ENTER to confirm.
2. Use the UP and DOWN buttons to select:
• MASTER/SLAVE – fixture runs in Master/Slave mode as described
under ‘Master/slave operation’ on page 21. The first fixture on the link
(master) automatically sends synchronizing information to other
connected fixtures (slaves).
• BLACKOUT – fixture blacks out.
• LAST STATE – fixture continues to obey the last command that was
sent via DMX.
3. Press ENTER to confirm (or press MENU to exit without making a
change).
Automatically turn off display backlight
By default the display is lit when power is applied to the fixture. It can be set to
automatically dim when the control panel has not been used for a period:
1. Select BACK LIGHT and press ENTER to confirm.
2. Use the DOWN and UP buttons to select OFF (display goes into sleep
mode) or ON (display remains lit constantly)
3. Press ENTER to confirm (or press MENU to exit without making a
change).
Fixture settings
Pan Reverse
To adjust the pan settings:
1. Select PAN REVERSE and press ENTER to confirm.