RoboColor II System users guide
INTRODUCTION 3 HOW TO INSTALL THE ROBOCOLOR II SYSTEM 3 OPERATING WITHOUT A LIGHTING CONTROLLER - STAND ALONE 4 OPERATING STAND ALONE IN MASTER/SLAVE MODE 4 OPERATING WITH A MARTIN LIGHTING CONTROLLER 5 DIP SWITCH SETTINGS FOR THE ROBOCOLOR II SYSTEM 6 TECHNICAL SPECIFICATIONS 7 INTRODUCTION The RoboColor II is a high performance, intelligent special-effect spotlight which features: _ _ _ _ _ _ _ _ _ _ _ _ 11 dichroic colors, plus white and black-out. 250W/120V ENH lamp. Color mixing.
HOW TO INSTALL THE ROBOCOLOR II SYSTEM Basically, a 'RoboColor II System' consists of two different types of components: The 'RoboColor II' units and the 'RoboColor II Controller'. The RoboColor II units are the colorchanging spotlights and the RoboColor II Controller is the "driver" for these spotlights. You can connect either Two or Four RoboColor II units on one RoboColor II Controller. WARNING Do not attempt to operate the RoboColor II units without the RoboColor II Controller (e.g.
OPERATING WITHOUT A LIGHTING CONTROLLER - STAND ALONE You can now operate the RoboColor II System in the Stand Alone mode which means that the RoboColor II units will perform a pre-programmed performance at a pre-set speed or triggered by sounds picked up by the microphone built into the RoboColor II Controller. Before switching on the RoboColor II Controller, you will need to set the DIP switch according to the chosen sequence (program).
DIP SWITCH SETTINGS FOR THE ROBOCOLOR II SYSTEM Unit no. 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 Address settings for the RoboColor II System Unit no.
TECHNICAL SPECIFICATIONS RoboColor II Dimensions with/without bracket: Length Width Height Weight: Power consumption: AC-voltage on lamp (recommended): Beam angle: Standard Optional wide angle Lamp: RoboColor Dimensions: Length Width Height Weight: AC-voltage: 220 V model 110 V model AC-frequency: Fuse 180 mm / 180 mm 200 mm / 160 mm 220 mm / 150 mm 3.0 Kg 250 W 115 V RMS 18° 27.5° 250 W / 120 V ENH II Controller 276 mm 125 mm 85 mm 2.