Operator`s manual

Roboscan Pro 1220 - operator’s manual 19

PSEt - Protocol Setup

After switching on a Pro 1220, it will automatically detect whether Martin or DMX signals are

received and use the appropriate

protocol type

. The PSEt (protocol set-up) function allows you to

switch protocol and/or protocol type afterwards. Use the arrow keys to select the desired protocol

and press [enter] to confirm or [menu] to cancel. Either way you will return to the main menu.

The protocol set-up function is also used to set the default DMX protocol, which is the protocol that

is automatically selected if DMX signals are received right after having switched on the fixture.

The following table shows the protocols available:

SPEC - Special Functions

Selecting this function presents you with a menu of special functions. As in the main-menu, you

can browse through the options and select the one displayed by pressing [enter].

dISP

Use the arrow keys to toggle between on and off. Select 'on' by pressing [enter] if you wish the dis-

play to blackout 2 minutes after the last pressing of any of the keys in order to avoid audience dis-

traction. Otherwise, select 'off'. The blackout function will not affect the appearance of error and

information messages.

Auto

This option can be used to disable the protocol auto-detect function when switching on the fixture.

Protocol # Protocol Type

Pan/Tilt

Resolution

Channel

Requirements

CMYR / XR /

RPR Control Principle

0 Martin RS-485 16 bit 2 / 2 / 2 Vector

1 (

DMX default)

DMX 512 8 bit 15 / 11 / 13 Tracking

2 DMX 512 16 bit 17 / 13 / 15 Tracking

3 DMX 512 8 bit 17 / 13 / 15 Vector/Tracking

4 DMX 512 16 bit 19 / 15 / 17 Vector/Tracking