User manual

RUSH DC1 Aqua User Manual
21
Note that the fixture will not respond to DMX commands while you are
controlling effects in the Manual menu. To restore DMX control, exit the
Manual menu.
Auto test
To perform a complete test of all of the fixture functions:
1. Select AUTO TEST and press ENTER. The fixture will run a self-test
routine.
2. Press MENU to exit the test.
Temperature
To check the onboard temperature of the fixture:
1. Select FIXTURE TEMP. and press ENTER. The display will show the
temperature of the unit.
2. Press MENU to exit.
Fixture operating hours readout
Fixture Hours
1. To display the fixture’s operating hours counter:
2. Select FIXTURE HOURS and press ENTER. The display will show the
number of hours the fixture has been in operation since manufacture.
3. Press MENU to exit.
Software version
To display the fixture’s installed fixture software (firmware) version number:
1. Select SOFTWARE VERSION and press ENTER. The display will show
the installed version.
2. Press MENU to exit.
Reset
The fixture resets each time you power it on, but you can also reset the fixture
manually. To carry out a manual reset:
1. Scroll to RESET and press ENTER to reset the fixture (or press MENU to
exit without resetting).
2. A reset takes approx. 20 seconds. After this, the fixture returns to its state
before the reset.