User Manual

RUSH Wizard User Manual 31
requirements in your particular situation. If in doubt, consult your RUSH by
Martin dealer about a suitable maintenance schedule.
Use gentle pressure only when cleaning, and work in a clean, well-lit area. Do
not use any product that contains solvents or abrasives, as these can cause
surface damage.
To clean the fixture:
1. Disconnect the fixture from power and allow it to cool for at least 30
minutes.
2. Vacuum or gently blow away dust and loose particles from the outside of
the fixture and all air vents with low-pressure compressed air.
3. Clean optical components by wiping gently with a soft, clean lint-free cloth
moistened with a weak detergent solution. Do not rub the surface hard: lift
particles off with a soft repeated press. Dry with a soft, clean, lint-free
cloth or low-pressure compressed air. Remove stuck particles with an
unscented tissue or cotton swab moistened with glass cleaner or distilled
water.
4. Check that the fixture is dry before reapplying power.
Servicing the lamp
Warning! Read ‘Lamp safety’ on page 7 before
servicing the lamp.
To avoid the risk of a discharge lamp exploding in the fixture, replace the lamp
before its expected lifetime (see ‘Lamp’ on page 44) has been exceeded.
Install only a lamp that is approved by Martin for this product.
The lamp must be perfectly clean. Do not touch the lamp’s glass bulb with
bare hands. If this happens, clean the lamp with an alcohol wipe and dry it
with a clean, lint-free cloth.
To replace the lamp:
1. Disconnect the fixture from power and allow it to cool for at least 30
minutes.
2. See illustration ‘Cover screws’. Place the fixture on a flat work surface
with its mounting bracket facing upwards and remove the 9 Phillips cover
screws (arrowed).