Manual

11
English
+
Speaker
Level
Input
–
Left In
+
Speaker
Level
Input
–
Right In
Line Level
Input
LFE In
Dynamo
Subwoofer
LFE Out
Receiver/Processor
Figure 16. Signal connection for multi-channel mode.
+
Speaker
Level
Input
–
Left In
+
Speaker
Level
Input
–
Right In
Line Level
Input
LFE In
Dynamo
Subwoofer
Receiver/Processor
LFE Out
Figure 17. Signal connection for multi-channel mode.
7 Use the bass management section of your receiver/proces-
sor’s speaker setup to set the subwoofer level at an appropriate
level. Follow the instructions in your processor’s manual to fine-
tune the subwoofer level.
8 If you have completed steps 1–7 and still have weak or boom-
ing bass consider using the Subwoofer Control App to further
adjust the 20–30Hz Level to compensate for these anomalies
(yes, you're tweaking the 20–30Hz Level again). Experiment
with the settings and listen to the result. Try to find a position
that sounds correct to you. Experiment by changing the Volume
(level) setting while adjusting the 20–30Hz Level. Find a posi-
tion that gives you deep extended bass and good blending
with your main speakers. If you still have weak or booming
bass you may want to consider moving your subwoofer and
go through these setup steps again (especially if it is located in
or near a room corner). Remember, room position has a major
impact on overall bass performance.