User Manual

3.4 CONNECTING MONO SPEAKERS

USING ONE BRIDGED ZONE

A zone set to mono mode can be used to drive a single speak-

er, allowing the MDA to deliver more power per channel. En-

abling mono bridge sets the listening mode to mono automat-

ically. Bridge mode only supports speakers rated for 8 Ohms

or higher. Any zone set to Mono Bridge can use an active sub

connected via the zone’s Sub Out. An odd-numbered zone set

to Mono Bridge can use the matching even-numbered zone to

power a passive subwoofer using the Powered by Zone 2 (4,

6, or 8) setting.

Speaker Connection:

1. Remove the Euroblock connector by gently pulling it until

it releases.

2. Use a small slotted screwdriver to loosen and tighten each

contact on the Euroblock when inserting the speaker wire.

3. Connect the red (+) connection of the speaker to the pos-

itive (R+) contact on the Euroblock connector as indicated

by the printing located on the MDA (below the connec-

tor).

4. Connect the black (–) connection of the speaker to the

negative (L–) contact on the Euroblock connector as indi-

cated by the printing located on the MDA (below the con-

nector).

Enabling Bridge Mode:

1. Enable bridge mode via the web interface by going to

Zones and selecting Mono Bridge in the desired zone. The

Listening Mode is set automatically set to Mono.

ANALOG OUT

L+R