Owner's Manual

ManualsBrandsMartinLogan ManualsDolby Atmos enabled speakersMotion® AFX

Table Of Contents

user’s manual

Summary of content (8 pages)

PAGE 1
user’s manual
PAGE 2
WARNING! • Refer servicing to a qualified technician. • To prevent fire or shock hazard, do not expose this module to moisture. • Turn amplifier off should any abnormal conditions occur. • Do not drive speaker beyond its rated power. The lightning bolt flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of potentially “dangerous voltage” within the product’s enclosure that may be sufficient to constitute a risk of electric shock. Connection . . . . . .
PAGE 3
PAGE 4
CONNECTION WARNING! Turn your amplifier off before making or breaking any tact and ease of installation. Hand tighten the binding posts, but do not overtighten—do not use signal connections! a tool to tighten the binding posts. Use the best speaker cables you can. The length and type of speaker cable used in your system will have an audible effect. Under no circumstance Be consistent when connecting the speaker cables.
PAGE 5
er function, please consider the following when installing your Motion AFX speakers. • Add Motion AFX speakers in pairs (2 or 4 speakers). If using only 2 Motion AFX they must be placed with your front left/right speakers. If using 4, they must be placed with your front left/right and back surround left/right or side surround left/right if you do not have back speakers. • Make sure the Motion AFX’s output is not blocked and points at the ceiling and towards the primary listening position.
PAGE 6
TROUBLESHOOTING No Output • Check that all system components are turned on and source material is playing. • Check speaker wires and connections. • Check all interconnecting cables. • If you are unable to resolve your problem, please contact your dealer or MartinLogan customer service (see below). CONTACTING CUSTOMER SERVICE MartinLogan customer service is available Monday–Friday between the hours of 8am–5pm (central time) by calling (785) 749-0133 or by emailing service@martinlogan.com.
PAGE 7
SPECIFICATIONS* Frequency Response . . . . . . . . . . . . . . . . . . . . . 90–20,000 Hz ± 3 dB Sensitivity. . . . . . . . . . . . . . . . . . . . . . . . . . . . . 87 dB @ 2.83 volts/meter Impedance . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Ohms. Compatible with 4, 6 or 8 Ohm rated amplifiers. Crossover Frequency. . . . . . . . . . . . . . . . . . . . . 2,000 Hz High Frequency Driver . . . . . . . . . . . . . . . . . . . 0.75” (1.9cm) aluminum dome Low Frequency Drivers . . . . .