User`s manual

Exos Crossover for the Monolith III speaker system Page 5
BASS OUTPUT
balanced on
INPUT MUTE
input
When lit, indicates that balanced inputs are in use
by the EXOS crossover. This button should be pressed to
light the indicator LED if you are using balanced XLR
connectors. Otherwise, press the button to toggle the
LED off if RCA connectors are used.
When lit, indicates that the outputs of the EXOS
are disconnected so that no signal reaches the power
amplifiers.
mute
This knob controls the overall
level of bass relative to the rest of the
music. Use it to adjust the amount of
bass according to your taste or for
matching the output level of your bass
amplifier to that of your treble amplifier.
Rotate to the left for less bass, to the
right for more. Use this to
fine-tune the bass after
properly setting the 40Hz and
80Hz contour controls.
bass output
The EXOS uses precision push-
buttons with LED indicators. A lit
LED indicates that the button's
function or option is on. The MUTE
and BALANCED buttons toggle the
option on and off. The CONTOUR
buttons select the level of bass at the
frequency option.
An internal battery provides power to
store your crossover settings in case
of AC power interruption.
Push-Buttons
Battery Backup
Warning: Do not have both the RCA and balanced
XLR connectors hooked-up simultaneously and attempt
to use this button as an A/B switch. You will have
degraded performance and possibly damage your equip-
ment. Only one type of connector should be used
throughout your system.