User`s manual

Exos Crossover for the Monolith III speaker system Page 7
After all signal connections
have been made and you have
verified that the power amps are off,
install the AC cord into the EXOS
first and then plug the other end
into the outlet. The power cord
should not be installed, removed or
left detached while the other end is
plugged into an AC outlet.
power connection
115-230 VAC (20VA)
Do not open. No user
serviceable parts in-
side. Keep away from
moisture.
©1995 ALL RIGHTS RESERVED
right
left
,
SIGNAL
INPUTS
right
left
SIGNAL
INPUTS
Input Connections
preamplifier connection
Connect the outputs of your preamplifier
to the respective inputs of the EXOS crossover.
You may use either single-ended cables with
RCA connectors or balanced cables via XLR
connectors. Do not mix connector types or use
both at once, use only one type at a time.
3) monolith interface
Next, connect the speaker leads from the
high-pass amplifier to the HI SIGNAL INPUTS
on the back of the MONOLITH III SPEAKERS.
Then connect the low-pass amplifier signal leads
to the LO SIGNAL INPUTS on the back of the
MONOLITH III SPEAKERS. Use spade connec-
tors for optimum contact and ease of installation.
Make certain that all of your connections are
clean, tight and positive. Be consistent when
connecting the speaker cables to the SIGNAL
INPUT terminals. Take care to assign the same
polarity cable lead to the (+) terminal on both
the left and right channel speakers.