Owner's Manual

10
EN
|
Preparing the 2 Conductor Burial Cable (For Mono Setup)
1. Starting with the
first speaker and
every speaker/
sub that comes
after, create a
loop approximate-
ly 6” in length.
3. Use a round
cable stripper to
remove the outside
protective cable
jacket to expose
the two color-
coded wires.
Separate the
wire loops
as shown.
2. Recommended:
Use a wire tie
(not included) to
keep the wire
loop intact and
it will act as a
strain relief.
4. Cut the red (+)
and black (-)
wires with cable
strippers and
strip off 1 inch
(25.4mm) of
insulation to
expose the bare
wire conductor.
red (+) black (-)