User's Manual

10
6. To attach the
speaker to the
surface mount
bracket base:
a) First hand
thread the twist
cap to the
surface mount
bracket base.
b) Now firmly
tighten the
twist cap with
the provided
wrench.
5. Thread the
speaker wire
through the
center hole
and out of the
wire opening
on the surface
mount bracket
base. Place
surface mount
bracket base
flush against
the surface you
wish to install
your speaker. To
attach surface
mount bracket
base to the
surface, use
appropriate
screws (not supplied) for your installation. For specifications
on screws, see your dealer for details.
Note: For a wall mounted installation where a wire connection
is contained within the surface mount bracket base, please
follow these instructions. It is recommend that the speaker wire
be cut short and the wire sleeve should be removed to expose
the red (+) and black (-) wires. Follow steps 6 a-b, but do not
attach the assembled speaker with surface mount bracket base
until your wire connections are made with silicone-filled wire
connectors covering the exposed wire connections. The wire
connections with silicone- filled wire connectors must be stuffed
inside the surface mount bracket base before attaching to the
desired surface with appropriate screws (not supplied) for your
installation. For specifications on screws, see your dealer for
details.
a)
b)
For wiring instructions see ‘Speaker &
Burial Cable Connections’ on page 11.