User Manual

6
Dynamo
™
Outdoor SUB 100
Place the subwoofer into the hole, ensure there is approximately
5” between the ground level and the bottom of the canopy.
Dynamo
™
Outdoor SUB 120 (See diagram)
Place the assembled subwoofer into the hole, then rotate the
subwoofer cabinet until there is approximately 5” between
the ground level and the bottom of the canopy. Once the
positioning of the subwoofer is satisfactory, tighten the
compression clamp that holds the elbow port to the subwoofer.
IMPORTANT! Do not backfill hole until your system
is fully WIRED/tested.
Dynamo
™
Outdoor SUB 100
To assemble, place the canopy into the port tube and
tighten the compression clamp so to ensure a water
tight seal.
Dynamo
™
Outdoor SUB 120 (See diagram)
Note: The port elbow is clearly marked “To Canopy” and “To
Subwoofer”.
Step 1: Insert the canopy onto the one end of the port elbow
until it is seated properly. Fully tighten the compression clamp.
Step 2: Attach the assembled canopy and elbow port to the
subwoofer, ensuring that dirt and other debris do not enter the
port tube. Do not fully tighten the compression clamp that holds
the elbow port to the subwoofer.
Shown: Dynamo
™
Outdoor SUB 120
SUBWOOFER ASSEMBLY
SUBWOOFER POSITIONING
Ground
Level
Example 1
Example 2
Example 3
5”
16”
16”
32”
16”
16”
32”
Shown: Dynamo
™
Outdoor SUB 120
Step 1 Step 2