User Manual

8
Mono Setup Using 4 Conductor Burial Cable & Crown Amplifier
Preparing the 4 Conductor Burial Cable
WIRING & SUBWOOFER INSTALLATION
1. Starting with
the first speaker
and every
speaker/sub
that comes after,
create a loop
approximately
6” in length.
3. Use a Round
Cable Stripper
to remove
the outside
protective cable
jacket to expose
the four color-
coded wires.
Separate the
wire loops as
shown.
2. Recommended:
Use a wire tie
(not included) to
keep the wire
loop intact and
act as a strain
relief.
4. Cut the white (+)
and green (-)
wires with cable
strippers and
strip off 1 inch
(25.4mm) of
insulation from
the ends of the
wires to expose
the copper
conductor.
Wires for
Subwoofer
green (+) &
white (-)
Wires for
Speaker
red (+) &
black (-)
MonoMonoMonoMonoMonoMonoMonoMono
SAT 40 OR SAT 60 (70V or 8-Ohm)
SUB 100 OR SUB120 (8 Ohm)
Speakers and subs should be
wired in parallel, not series.