User Manual

7
the speaker. Take great care to assign the
same color to the (+) terminal on both the
speaker and the amplifier.
6 Place the speaker in the hole.
7 Orient the tweeter so it is pointing towards
the primary listening position. There is an
arrow on the installation handle to help with
this. Hold the speaker in place by the instal-
lation handle. Tighten all screws numbered
“1” in the direction labeled on the installation
handle to engage mounting locks. Use the
supplied Torx T20 driver and an electric drill
to lock all mounting locks in place. Use a low
clutch setting on the drill.
8 Loosen the screws numbered “2” to remove
the installation handle.
9. Adjust the switches (figure 8). Set the Position
switch to reflect the speaker’s location in the
room. For a center channel, choose either
setting. Set the Tweeter Level switch to the
desired setting (+2dB, –2dB, or 0).
10 Remove the protective sticker that is covering
the Folded Motion tweeter.
11 Place the magnetic grille over the speaker.
7.36” (18.7cm)
12.68” (32.2cm)
Required opening
(including tolerance):
11.46” (29.1cm)
Fig. 7
Fig. 8