Owner's Manual
Table Of Contents
- User's Manual
- Content Check List
- Safety Warnings and WEEE Recycling
- Square Grilles, Pre-Installation Brackets, & Backboxes
- Protect Your Investment
- Break-In
- General Speaker Placement
- Placement Options (All Models)
- Placement Options (Aimable XTC8-HT Speaker)
- Connection
- Installation
- Speaker Installation and Connection (pictorial)
- Painting the Speaker Grille
- Frequently Asked Questions
- Troubleshooting
- Warranty
- Specs XTCW6
- Specs XTC8
- Specs XTC8-HT
- Specs XTW5-LCR
- Specs XTW6-LCR
Painting the Speaker Grille
IMPORTANT! Before painting remove grille from speakers. Do not paint the surface of the speaker
behind the grille. Do not use a paint roller.
1. Remove the grille from the speaker.
2. Paint the grille, being careful not to plug the holes. For best results use a spray rather than
a brush. Allow the paint to completely dry before proceeding. Do not paint the surface
behind the grille.
NOTE: Retrofit Back Boxes are available for all in-ceiling Motion series speakers. These back
boxes reduce sound from “leaking” into the area above where the speaker is installed. For
example, if building a home theater downstairs and there are living spaces directly above where
the speakers are installed it may be desirable to use these back boxes to help contain the sound so
it does not cause any disturbance to those above the speakers.
13