Owner`s manual

178
MH0-74E
EXAMPLE
MH0-07-014
EXAMPLE
MH0-07-014
6) Position the jack vertically and raise the
jack by turning the jack handle clockwise
until the jack head groove fits around the
jacking bar beneath the vehicle body.
See illustrations.
WARNING
 Use the jack only to change wheels
on level, hard ground.
 Never jack up the vehicle on an
inclined surface.
 Never raise the vehicle with the jack
in a location other than the specified
jacking point (shown in the illustra-
tion) near the wheel to be changed.
 Make sure that the jack is raised at
least 51 mm (2 inches) before it
contacts the flange. Use of the jack
when it is within 51 mm (2 inches)
of being fully collapsed may result
in failure of the jack.
 Never get under the vehicle when it
is supported by the jack.
 Never run the engine when the
vehicle is supported by the jack and
never allow passengers to remain in
the vehicle.
7) Continue to raise the jack slowly and
smoothly until the tire clears the ground.
Do not raise the vehicle more than
necessary.
To Raise the Vehicle with a Garage
Jack
 Apply the garage jack to one of the
points indicated below.
 Always support the raised vehicle with
jack stands (commercially available) at
the points indicated below.
(1)
Front jacking point for garage jack (1)
EXAMPLE
MH0-07-014
EMERGENCY SERVICE
10-2