MARVEL REFRIGERATED BEVERAGE CENTER Installation Operation and Maintenance Instructions Refrigerated Beverage Center 3BARM & 6BARM
UNPACKING YOUR BEVERAGE CENTER Remove Packaging Your beverage center has been packed for shipment with all parts that could be damaged by movement securely fastened. Before using, be sure all packing materials and tape have been removed. Important Keep your carton packaging until your beverage center has been thoroughly inspected and found to be in good condition. If there is damage, the packaging will be needed as proof of damage in transit.
INSTALLING YOUR BEVERAGE CENTER Select Location The proper location will ensure peak performance of your appliance. Choose a location where the unit will be out of direct sunlight and away from heat sources. Best performance will be maintained when installed within the following parameters: Electrical Plug Optional Location: Cutout shown for electrical outlet which can be located in adjacent cabinetry.
MICROSENTRY™ REFRIGERATION MONITOR Door Switch Alarm Light Switch Set Control Press and Hold Start Your Appliance To start your appliance, plug it into a power supply. Push and hold the “ON/OFF” button located on the display panel for three (3) seconds (see Figure 3). NOTE: The unit may take 5 to 10 minutes to start. Once the bottles are loaded, allow at least 48 hours for the unit to stabilize before making any adjustments to the initial setting.
MICROSENTRY™ REFRIGERATION MONITOR Warning Alarms Your beverage center has been fitted with a MicroSentry™ refrigeration monitor. This monitor will let you know if your cellar is not functioning properly for optimum wine and beverage storage. Door Ajar Alarm If the door has been left open for over five (5) minutes, the alarm will sound in one (1) second intervals. The display panel will flash “Do” and the LED light will be a steady amber color. This will stop as soon as the door is closed.
3BARM BEVERAGE CENTER FEATURES Insert Wine Bottles The wine rack pull-out shelf holds four (4) bottles. See Figure 4 for typical wine bottle orientation. The wine rack can be located at the middle or bottom part of the interior cabinet. For red wines, place wine shelf at bottom shelf position in the cabinet. Then put a glass shelf in the next higher position. For white and sparkling wines, put the wine shelf on the middle shelf position in the cabinet. Place the remaining shelves as desired (see Figure 5).
6BARM BEVERAGE CENTER FEATURES Insert Wine Bottles The wine rack pull-out shelf holds eight (8) bottles. See Figure 7 for typical wine bottle orientation. The wine rack can be located at the middle or bottom part of the interior cabinet. For red wines, place wine shelf at bottom shelf position in the cabinet. Then put a glass shelf in the next higher position. For white and sparkling wines, put the wine shelf on the middle shelf position in the cabinet. Place the remaining shelves as desired (see Figure 8).
CARE AND CLEANING OF YOUR BEVERAGE CENTER Condenser The condenser tubing inside the cabinet does not require frequent cleaning; however, satisfactory cooling depends on adequate ventilation over the coils. Be sure that nothing obstructs the required air flow openings in front of the cabinet. At least once or twice a year, brush or vacuum lint and dirt from the condenser for efficient performance by unscrewing the grille on the bottom front of the cabinet.
TROUBLESHOOTING YOUR BEVERAGE CENTER Before Calling for Service Before calling for service, check the troubleshooting table on this page. This table lists possible problems that you can remedy without difficulty to avoid an unnecessary service call. PROBLEM Odor in cabinet Noisy operation Cabinet vibrates Cabinet light not working POSSIBLE CAUSES/SOLUTIONS 1. Interior needs cleaning 1. Cabinet not level 2. Weak floor 1. Cabinet not level 2. Weak floor 1. Tube burned out 2. No power at outlet 1.
OBTAINING SERVICE FOR YOUR BEVERAGE CENTER If You Do Need Service If you do need service, contact your dealer or Marvel Industries. In any correspondence, refer to the model number and serial number of your unit which is located on the upper left hand side of the wall liner. Retain your proof of purchase. You may want to record these numbers in the space below.
HOUSEHOLD PRODUCT WARRANTY Entire Product Limited One Year Parts and Labor Warranty Marvel warrants that it will supply all necessary parts and labor to repair or replace in the end user’s home or office, any component which proves to be defective in material or workmanship, subject to the condition and exclusions stated below, for a period of one year from the date of purchase by the end user.
www.lifeluxurymarvel.com Marvel Industries P.O. Box 997 Richmond, IN 47375-0997 800.428.6644 An AGA Company 41010735 Rev. E 03.03.08 All specifications and product designs subject to change without notice. Such revisions do not entitle the buyer to corresponding changes, improvements, additions, replacements or compensation for previously purchased products.