Troubleshooting guide
INSTALLING YOUR REFRIGERATOR
Leveling Legs
Front Grille, keep
this area open.
Figure 1
Select Locaon
The proper locaon will ensure peak performance of your ap-
pliance. We recommend a locaon where the unit will be out
of direct sunlight and away from heat sources. To ensure your
product performs to specicaons the recommended installaon
locaon temperature range is from 55 to 100°F (13 to 38°C).
Cabinet Clearance
Venlaon is required from the boom front secon of the unit.
Keep this area open and clear of any obstrucons. Adjacent
cabinets and counter top can be installed around the unit as long
as the grille and door access remain unobstructed.
Figure 2
Rear of unit
Rear leveling legs
at outside corners
Center rear leveling
leg on 30” wide units
only
Access cover
removed
Leveling Legs
Adjustable legs at the front and rear corners of the unit should
be set so the unit is rmly posioned on the oor and level from
side to side and front to back. The overall height of your Marvel
refrigerator may be adjusted from 33-3/4” (85.7cm) with the
leveling legs turned in, and up to 34-3/4” (88.3cm) with the lev-
eling legs extended. The 80 cabinets (30” wide) have a center leg
at the rear of the cabinet that must also be used to stabilize the
cabinet. (See Figure 2).
To adjust the leveling legs, place the refrigerator on a solid sur-
face and protect the oor beneath the legs to avoid scratching
the oor. With the assistance of another person, lean the refrig-
erator back enough to access the front leveling legs and remove
the weight. Raise or lower the legs to the required dimension
by turning the legs. Repeat this process for the rear by lng
the refrigerator forward using cauon to prevent the door from
opening. On a level surface check the refrigerator for levelness
and adjust accordingly.
The front grille (toe kick) screws may be loosened and adjusted
to the desired height. When adjustment is complete ghten the
two toe kick screws. (See Figure 2).
4
Front Grille
Do not obstruct the front grill. The openings within the front
grill allow air to ow through the condenser heat exchanger.
Restricons to this air ow will result in increased energy usage
and loss of cooling capacity. For this reason it is important this
area to not be obstructed and the grill openings kept clean. AGA
MARVEL does not recommend the use of custom made grills as
air ow may be restricted because of inadequate openings. (See
Figure 1).