Owners Guide

Installation Operation and Maintenance Instructions

General Installation

LEVELING INFORMATION

1. Use a level to conrm the

unit is level. Level should

be placed along top edge

and side edge as shown.

2. If the unit is not level, adjust the legs on the corners of the

unit as necessary.

3. Conrm the unit is level after each adjustment and repeat

the previous steps as needed.

INSTALLATION TIP

If the room oor is higher than the oor in the cutout opening,

adjust the rear legs to achieve a total unit rear height of 1/8” (3

mm) less than opening’s rear height. Shorten the unit height in

the front by adjusting the front legs. This allows the unit to be

gently tipped into the opening. Readjust the front legs to level

the unit after it is correctly positioned in the opening.

INSTALLATION

1. Plug in the power/electrical cord.

2. Gently push the unit into position. Be careful not to

entangle the cord or water and drain lines, if applicable.

3. Re-check the leveling, from front to back and side to

side. Make any necessary adjustments. The unit’s top

surface should be approximately 1/8” (3 mm) below the

countertop.

4. Install the anti-tip bracket.

5. Remove interior packing material and wipe out the inside

of the unit with a clean, water-dampened cloth.

Grille Installation

REMOVING AND INSTALLING GRILLE

Disconnect electric power to the unit before removing the

grille.

When using the unit, the grille must be installed.

DO NOT touch the condenser ns. The condenser ns are

SHARP and can be easily damaged.

Removing the grille

1. Disconnect power to the unit.

2. Loosen the two screws (1).

3. Remove grille (2) from unit.

Installing the grille

1. Align cabinet and grille holes and secure, but do not over

tighten grille screws (1).

2. Reconnect power to the unit.

Turn to Adjust

WARNING