Quick Reference Guide

11
INTERIOR SHELVES (MLBV024)
Removing and Installing Interior Shelves
For models equipped with glass shelves having
recessed shelf supports, remove the shelves as follows:
1. Pull shelf out about 6” (1), until back of shelf clears
the “hump” on the right-hand side.
2. Tilt up right-hand edge of shelf (2).
3. Remove shelf from unit by pulling out (3).
Insert the shelves as follows:
1. 󰀨
at an angle, approximately 15-20°, over the rib in the
side of the unit where you want to place the shelf.
Place the shelf into the unit at an angle to clear the
door.
2. Continue to slide the shelf into the unit at an angle
until it clears the door. Lower the shelf and push it in
completely. Ensure the raised edge strip is toward
the rear of the unit.
Make sure the shelves are inserted fully into the unit.
The edge strip toward the rear prevents cans and bottles
from freezing against the cold evaporator.
2
3
1
Figure 27
NOTE
INTERIOR ADJUSTMENTS