Quick Reference Guide

8
Reversing the Door
Location of the unit may make it desirable to mount the
door on the opposite side of the cabinet.
The hinge hardware will be removed and reinstalled on the
opposite side of the cabinet.
TO REVERSE THE DOOR
Remove Grille:
Remove the grille (see GRILLE INSTALLATION section of
this guide).
Remove top hinge and door:
1. Hold door to keep it from falling.
2. Remove top hinge from cabinet by removing three
screws. Set aside and save for possible future use.
󰀨 
bottom hinge. Retain shoulder washers; they will be
reused.
4. Remove four screws from hinge holes on the
opposite side. Reinstall into holes where the hinge
was removed. Take care to not scratch cabinet.
Figure 13
Figure 14
Remove and reinstall bottom hinge:
1. Remove bottom hinge from cabinet by removing three
screws.
2. Remove corresponding screws on opposite side of
cabinet.
3. Flip hinge plate over and reinstall on opposite side.
Prepare door for reinstallation:
1. Remove gasket. This will reveal mounting holes for the
magnet assembly.
2. Remove magnet assembly from door with T-10 TORX
driver. Be sure to only remove the two screws holding
the assembly to the door. Reinstall on the opposite end
of the door.
3. Rotate gasket 180°, aligning notch with magnet

starting at the corners.
4. Rotate door 180° to reverse.
Figure 15
Install top hinge and door:
1. Use alternate hinge supplied with unit and reinstall the
screws. Do not tighten
.
2. Lift the door on to the bottom hinge.

unit.
4. Tighten three hinge screws.
Figure 16
Align and adjust the door:
Align and adjust the door (see ALIGNMENT AND
ADJUSTMENT).
Install grille:
Install the grille.
DOOR REVERSAL