Quick Reference Guide
9
INSTALLING THE ANTI TIP DEVICE
Anti-Tip Bracket
1. Slide unit out so screws on top of unit are easily
accessible.
2. Remove the two screws from the opposite side of the
hinge assembly using a T-25 Torx driver (see below).
3. Place bracket over holes and attach to unit with two
screws removed in step 2 using a T-25 Torx driver.
Tighten screws fully.
4. Gently push unit into position. Be careful not to entangle
the electrical cord or water line, if applicable.
5. Check to be sure the unit is level from front to back and
side to side. Make any necessary adjustments. The
unit’s top surface should be approximately ¹” (3 mm)
below the countertop.
6. Secure bracket onto adjoining surface.
Figure 17 Figure 18
Leveling Information
1.
placed along top edge and side edge as shown.
2. If the unit is not level, adjust the legs on the corners of
the unit as necessary.
3.
repeat the previous steps as needed.
1
Figure 19
Turn to Adjust
Figure 20
-
ing, adjust the rear legs to achieve a total unit rear height of
¹” (3 mm) less than opening’s rear height. Shorten the unit
height in the front by adjusting the front legs. This allows
the unit to be gently tipped into the opening. Readjust the
front legs to level the unit after it is correctly positioned in
the opening.
Installation
1. Plug in the power/electrical cord.
2. Gently push the unit into position. Be careful not to
entangle the cord or water and drain lines, if applicable.
3. Re-check the leveling, from front to back and side to
side. Make any necessary adjustments. The unit’s top
countertop.
4. Install the anti-tip bracket.
5. Remove interior packing material and wipe out the
inside of the unit with a clean, water-dampened cloth.
NOTE