GE T TING STARTED QUICK REFERENCE GUIDE M ARVEL UNDERCOUNTER REFRIGERATION MLBV215 MLBV124 MLBV224 MLRE215 MLRE024 MLRE124 MLRE224 MLDR224 MLKR224 M LW C 1 2 4 M LW C 2 2 4 M LW C 3 2 4 M LW C 2 1 5 T H E O R I G I N A L R E F R I G E R AT I O N E X P E R T S S I N C E 1 8 9 2
CONTENTS Contents: Important Safety Instructions Safety information ...............................................................2 Unpacking Your Appliance ................................................. 3 Installing your appliance ......................................................4 Electrical ..............................................................................5 Door Reversal .....................................................................6 Installing the anti-tip device ...........
UNPACKING YOUR APPLIANCE ! Warranty Registration WARNING It is important you send in your warranty registration card immediately after taking delivery of your appliance or you can register online at www.marvelrefrigeration.com. EXCESSIVE WEIGHT HAZARD Use two or more people to move product. Failure to do so can result in personal injury. The following information will be required when registering your appliance.
INSTALLING YOUR APPLIANCE Select Location The proper location will ensure peak performance of your appliance. We recommend a location where the unit will be out of direct sunlight and away from heat sources. To ensure your product performs to specifications, the recommended installation location temperature range is from 55 to 100°F (13 to 38°C). Front grille screws Cabinet Clearance Ventilation is required from the bottom front of the appliance. Keep this area open and clear of any obstructions.
ELECTRICAL Electrical Connection A grounded 115 volt, 15 amp dedicated circuit is required. This product is factory equipped with a power supply cord that has a three-pronged, grounded plug. It must be plugged into a mating grounding type receptacle in accordance with the National Electrical Code and applicable local codes and ordinances (see Figure 6). If the circuit does not have a grounding type receptacle, it is the responsibility and obligation of the customer to provide the proper power supply.
DOOR REVERSAL Door Reversing Instructions Tools Needed: • 1/8” Hex Key • 5/32” Hex Key • Phillips Screwdriver 1. Open door and remove Hinge Pin from the Upper Hinge using a 1/8” Hex Key tool (Fig. 6), making sure to steady the door Slowly remove the door from the Upper Hinge and lift to remove off the base Lower Hinge. 2. Using a Phillips Screwdriver, remove the 6 screws from both the Upper and Lower Hinges and save for later steps 3.
DOOR REVERSAL 6. Remove the Toe Kick from the door and attach it to the opposite side (Fig. 8). Figure 8 - Toe Kick Reversal 7. Reattach the Upper and Lower Hinges, and Hinge Brackets to opposite sides. Then install the door.
DOOR REVERSAL Reversing the Shelf Spacers Wine Rack Installation To remove rack from the cabinet: 1. Remove any bottles stored on the rack. 2. Grasp the end of the rack and gently slide it out until it stops. 3. Press the left rack release lever down. At the same time lift the matching right rack release lever up. Pull the rack out until it is free of the tracks and the cabinet. NOTE Do not remove the track rails from the cabinet. To reverse the shim pattern: 1.
INSTALLING THE ANTI TIP DEVICE Anti-Tip Bracket WARNING ! • ALL APPLIANCES CAN TIP RESULTING IN INJURY. • INSTALL THE ANTI-TIP BRACKET PACKED WITH THE APPLIANCE. • FOLLOW THE INSTRUCTIONS BELOW 211⁄2" (54.6 cm) Leveling Leg Bottom View of Appliance Front of cabinet Anti-Tip Device ! 12 WARNING Figure If your appliance is not located under a counter top (free standing), you must use an anti-tip device installed as per these instructions.
USING YOUR ELECTRONIC CONTROL Figure 13 Electronic control Control Function Guide Function Command Notes ON/OFF Press Unit will immediately turn ON or OFF. Leave Interior Light On Press and release to leave interior light on for 3 hours; press again to deactivate. After 12 hours, factory default is restored; light will turn on when door is open. Adjust Temperature Press or and release. When the display is flashing, press or to adjust the set point temperature.
CARE AND CLEANING Front Grille The following suggestions will minimize the cost of operating your refrigeration appliance. Be sure that nothing obstructs the required air flow openings in front of the cabinet. At least once or twice a year, brush or vacuum lint and dirt from the front grille area (see page 4). ! 1. Do not install your appliance next to a hot appliance (cooker, dishwasher, etc.), heating air duct, or other heat sources. 2. Install product out of direct sunlight. 3.
HOUSEHOLD PRODUCT WARRANTY Marvel Refrigeration (Marvel) Limited Warranty ONE YEAR LIMITED PARTS & LABOR WARRANTY For one year from the date of original purchase, this warranty covers all parts and labor to repair or replace any part of the product that proves to be defective in materials or workmanship. For products installed and used for normal residential use, material cosmetic defects are included in this warranty, with coverage limited to 60 days from the date of original purchase.
www.marvelrefrigeration.com Marvel Refrigeration 1260 E. Van Deinse St. Greenville MI 48838 616.754.5601 41015935 Rev A 1/20/21 All specifications and product designs subject to change without notice. Such revisions do not entitle the buyer to corresponding changes, improvements, additions, replacements or compensation for previously purchased products.
