Owner's Guide

Step 3: Attach the Integrated Panel to the

Drawer

1. Set the integrated panel on drawer front face and align

edges. The custom integrated panel should be flush

with the top of the drawer and centered on the width of

the drawer. Clamp panel in position and mark pilot hole

locations. Pick the required pilot hole size from the

table below and drill the pilot holes ensuring not to drill

all the way through the integrated panel.

Pilot Hole Drill Sizes for Wood Screws

Material Type #8 Wood Screw

Hardwood

⁄8 Diameter Pilot Hole

Softwood

⁄64 Diameter Pilot Hole

2. Insert wood screws through clearance holes and

tighten to secure integrated panel.

3. Reinstall gasket into channel. Make sure the corners

are fully inserted.

4. Place the drawer divider back into the drawer.

Integrated panel

ush with top

edge of drawer

Using clearance holes in

gasket channel mark

hole locations onto panel

Screw clearance

hole through

gasket extrusion

Custom

integrated panel

to be

centered on width

of drawer.

INTEGRATED PANEL INSTALLATION