OWNERS GUIDE MARVEL LOW PROFILE UNDERCOUNTER REFRIGERATION FOR MODEL # MARE224 THE ORIGINAL REFRIGERATION EXPERTS SINCE 1892
IMPORTANT SAFETY INSTRUCTIONS Important Safety Instructions Warnings and safety instructions appearing in this guide are not meant to cover all possible conditions and situations that may occur. Common sense, caution, and care must be exercised when installing, maintaining, or operating this appliance. Recognize Safety Symbols, Words, and Labels. ! WARNING WARNING - You can be killed or seriously injured if you do not follow these instructions.
TABLE OF CONTENTS Tip: Click on any section below to jump directly there Safety Important Safety Instructions Installation Unpacking Your Appliance Electrical Maintenance Care and Cleaning Extended Non-Use Operating Instructions Interior Adjustments Energy Savng Tips Service Obtaining Service Product Liability Ordering Replacement Parts R600a Specifications System Diagnosis Guide Compressor Specifications Control Operation - Service Warranty 3
UNPACKING YOUR APPLIANCE ! WARNING EXCESSIVE WEIGHT HAZARD Use two or more people to move product. Failure to do so can result in personal injury. Remove Interior Packaging Your appliance has been packed for shipment with all parts that could be damaged by movement securely fastened. Remove internal packing materials and any tape holding internal components in place. The owners manual is shipped inside the product in a plastic bag along with the warranty registration card, and other accessory items.
ELECTRICAL Electrical Connection A grounded 115 volt, 15 amp dedicated circuit is required. Do not remove ground prong This product is factory equipped with a power supply cord that has a three-pronged, grounded plug. It must be plugged into a mating grounding type receptacle in accordance with the National Electrical Code and applicable local codes and ordinances (see Figure 4).
INTERIOR ADJUSTMENTS ! Tall bottle storage area CAUTION Shelf load limit is 35 lbs. Overloading the shelf could result in deflection and risk of injury. Installed shelf tang Shelf support slot Rear tang (hook) on shelf Figure 43 Door storage racks To remove the crisper : Pull out until it stops. Lift up on the front of the pan, and remove it from the frame. Figure 42a To Add or Remove a Shelf Remove stored product from the shelf. Do not try to remove a loaded shelf from the appliance.
CARE AND CLEANING Front Grille Be sure that nothing obstructs the required air flow openings in front of the cabinet. At least once or twice a year, brush or vacuum lint and dirt from the front grille area (see page 8). ! CAUTION SHOCK HAZARD: Disconnect electrical power from the appliance before cleaning with soap and water. Cabinet The painted cabinet can be washed with either a mild soap and water and thoroughly rinsed with clear water. NEVER use abrasive scouring cleaners.
ENERGY SAVING TIPS The following suggestions will minimize the cost of operating your refrigeration appliance. 1. Do not install your appliance next to a hot appliance (cooker, dishwasher, etc.), heating air duct, or other heat sources. 2. Install product out of direct sunlight. 3. Ensure the front grille vents at front of appliance beneath door are not obstructed and kept clean to allow ventilation for the refrigeration system to expel heat. 4. Plug your appliance into a dedicated power circuit.
EXTENDED NON-USE Vacation/Holiday, Prolonged Shutdown The following steps are recommended for periods of extended non-use: 1. Remove all consumable content from the unit. 2. Disconnect the power cord from its outlet/socket and leave it disconnected until the unit is returned to service. 3. If ice is on the evaporator, allow ice to thaw naturally. 4. Clean and dry the interior of the unit. Ensure all water has been removed from the unit. 5. The door must remain open to prevent formation of mold and mildew.
OBTAINING SERVICE If Service is Required: • If the product is within the first year warranty period please contact your dealer or call Marvel Customer Service at 616.754.5601 for directions on how to obtain warranty coverage in your area. • If the product is outside the first year warranty period, Marvel Customer Service can provide recommendations of service centers in your area. A listing of authorized service centers is also available at www.marvelrefrigeration.
Ordering Replacement Parts Parts may be o rdered online at www.partsformarvel.com Or contact: www.marvelrefrigeration.com (Servicers choose "Login" for service account) Phone Numb er: +1.616.754.5601 NOTICE Use only genuine Marvel replacement parts. The use of non-Marvel parts can reduce performance, damage the unit, and void the warranty. Warranty parts will be shipped at no charge after Marvel confirms warranty status. Please provide the model, serial number, part number and part description.
Ordering Replacement Parts Parts may be o rdered online at partsformarvel.com Or contact: www.marvelrefrigeration.com (Servicers choose "Login" for service account). Phone Numb er: (616) 754-5601 NOTICE Use only genuine Marvel replacement parts. The use of non-Marvel parts can reduce performance, damage the unit, and void the warranty. Warranty parts will be shipped at no charge after Marvel confirms warranty status. Please provide the model, serial number, part number and part description.
R-600A Specifications & Handling Gloves and Eye Protection must be used. ,., . ���· ' R-600a is considered non-toxic, but is flammable when mixed with air. Keep a dry powder type fire extinguisher in the work area. R-600a is heavier than air, do not allow any leakage/migration to low areas such as basements and stairs. RISK Of FIRE OR EXPLOSION. FLAMMABLE REFRIGERANT USED. TO BE REPAIRED ONLY BY TRAINED SERVICE PERSONNEL DO HOT PUNCTURE REFRIGERANT TUBING RISK Of FIRE OR EXPLOSION.
IA WARNING I Only skilled and well trained service technicians permitted to service R-600a equipped products. R-600A SPECIFICATIONS/LABELING R-600a equipped products are labeled (both the unit and the compressor). R-600a is colorless and odorless. All tools and equipment must be approved for use with R-600a refrigerant. R-600a is considered non-toxic, but is flammable when mixed with air. Local, state and federal laws, standards must be observed along with proper certification and licensing.
Evacuate/reclaim via the piecing pliers to ensure the When re-brazing, the system must be purged with dry system is empty of R-600a before any system work is nitrogen and at least one access point open to the performed. atmosphere. When re-brazing, proper ventilation is required along with constant monitoring for the presence of R600a refrigerant. GAS LEAi< The filter dryer must be replaced any time the sealed system is serviced.
The low side of the refrigeration system (evaporator, Proper ventilation during service is required. compressor and suction line) must be leak tested with the compressor off (equalized pressure). Never apply a torch to a charged R-600a refrigeration system. RECHARGING No air is ever to be allowed inside the refrigeration system (R-600a refrigerant or dry nitrogen only). Use OEM replacement service parts and do not alter the construction of the unit.
System Diagnosis Guide REGRIGERATION SYSTEM DIAGNOSIS GUIDE Capillary Tube Evaporator Wattage Very hot Warm Cold Normal Slightly warm to hot Hot to warm Cool Cold Higher than normal Hot Warm Warm Extremely cold near inlet - Outlet below room temperature Lower than normal Somewhat Warmlower than near room normal vacuum temperature Very hot Top passes Room temperature warm Lower (cool) or colder passes cool (near room temperature) due to liquid Extremely cold near inlet - Outlet below room
Compressor Specifications A DANGER EMX20CLC REFRIGERANT R600A VOLTAGE 115 VAC FREQUENCY 60 Hz Electrocution can cause death or serious injury. START WINDING 7 Ohm at 77° F Burns from hot or cold surfaces can cause serious RUN WINDING 13 Ohm at 77° F injury. Take precautions when servicing this unit. RUN TO START 20 Ohm at 77° F LRA 3.7 A Disconnect the power source. Do not stand in standing water when working around electrical appliances. FLA 0.
Control Operation-Service CONTROL FUNCTION GUIDE FUNCTION UI BUTTON LAYOUT 2 3 / / 1. 4 / / 5 / 6 Hidden Button -Access Service Menu -No LED directly above. All LEDs turn on with button ON/OFF Sabbath Mode COMMAND DISPLAY/ OPTIONS Press � and release Unit will immediately turn ON or OFF See "Sabbath Mode" section SHOWROOM MODE This mode is designed to show units in a display environment. When in this mode the only functions will be the control and cabinet lights. The compressor, fans, etc.
HOUSEHOLD PRODUCT WARRANTY Marvel Refrigeration (Marvel) Limited Warranty ONE YEAR LIMITED PARTS & LABOR WARRANTY For one year from the date of original purchase, this warranty covers all parts and labor to repair or replace any part of the product that proves to be defective in materials or workmanship. For products installed and used for normal residential use, material cosmetic defects are included in this warranty, with coverage limited to 60 days from the date of original purchase.
