Use and Care Guide

7
NOTE
Ice-maker operation
The unit must be installed level for proper ice-maker
operation.
The shutoff arm wire must be down in its lowest posi-
tion for the ice-maker to operate. (See Figure 8).
When the freezer section and ice-maker unit has suf-
ciently cooled, the ice-maker will harvest ice cubes
automatically.
When the ice bucket is full, the ice-maker will automati-
cally shut off.
You may manually stop the ice-maker by raising the
shut off arm to the locking position at the up most posi-
tion. (See Figure 8).
Arm down, ice-maker
will operate
Arm up, stops operation
Figure 8
OPTIONAL ICE-MAKER OPERATION
!
CAUTION
The water supply to the ice-maker must be turned on prior
to turning the ice-maker on. Failure to do so will cause
rapid dry cycling of the ice-maker mold heater resulting in
temperature control issues in the freezer compartment.
It is recommended the ice-maker is shut off when remov-
ing the bucket, or ice may be dispensed onto the freezer
compartment oor.
If the ice is not used regularly, it will clump together with
time. For best ice results, discard ice in the bin as required
and allow the ice-maker to make a new fresh batch of ice.
Shut-off the ice-maker by raising the shut-off arm before
removing the bucket.