Owner's Manual

10
USING YOUR ELECTRONIC CONTROL
Control lock:
The control panel can be locked to avoid unintentional
changes. To lock the control, press and hold the "Lock" key-
pad until the display reads "Loc" then immediately release
your nger from the keypad. The lock icon will ash 3-times
and then continuously illuminate. When the control panel is
locked, only the Lock keypad, System Status OK indicator
, and the Alarm indicator are active. To un-lock the control
panel, repeat this instruction until the display reads "nLc",
then immediately release your nger from the keypad.
The temperature sensors are monitored continuously. Any
OPEN or SHORTED circuit condition will initiate an
ERROR CODE as listed below:
Temperature Sensor Error Codes
Temperature mode:
The temperature mode is preset from the factory in Fahren-
heit (°F) but you have the option to change it to Centigrade
(°C). To change the mode, press and hold the "-" keypad,
while pressing the "+" keypad, then release the "-" keypad.
The temperature will now be displayed in Centigrade (°C).
Repeat the procedure to change the temperature mode
back to Fahrenheit (°F).
To change the set temperature for a particular zone, with
the zone selected and out of sleep mode, press the "-" or
"+" keypads. "SET" will be indicated on the user interface
panel and the current set-point temperature will display
and ash. Subsequent presses of the "-" or "+" keypads
will adjust the temperature colder or warmer respectively.
When you have reached your desired set-point tempera-
ture, press the "On/Off" keypad to accept, or do nothing
and the "Set" mode will time-out in 10-seconds accepting
the displayed temperature as the new set-point.
The available set-point temperature range for your appli-
ance is 34°F (1.2°C) to 42°F (5.7°C) for the lower zone
and 45°F (7°C) to 60°F (16°C) for the upper zone. If you
attempt to adjust the temperature outside of these ranges
you will receive an audible notication.
NOTE
The upper zone is designed exclusively for the storage of
wine. The upper zone cannot attain storage temperatures
suitable for fresh food storage.
Temperature Sensor Error Codes
Sensor Displayed Code Error Description Action to Take
Single Zone
Temperature Sensor
Failed temperature sensor in the single
zone compartment. Can lead to unwant-
ed wine storage temperatures.
Call service to have the tem-
perature sensor replaced.
Defrost Sensor
Failed defrost temperature sensor.
Causes unit to not defrost properly and
can create large frost build-up. Can lead
to water damage to the unit and sur-
rounding oor.
Unplug the power cord imme-
diately and call service to have
the defrost sensor replaced.
Single Zone Models:
Dual Zone Models:
Temperature Sensor Error Codes
Sensor Displayed Code Error Description Action to Take
Upper Zone
Temperature Sensor
Failed temperature sensor in the upper
zone compartment. Can lead to unwant-
ed wine storage temperatures.
Call service to have the tem-
perature sensor replaced.
Lower Zone
Temperature Sensor
Failed temperature sensor in the lower
zone compartment. Can lead to unwant-
ed wine storage temperatures.
Call service to have the tem-
perature sensor replaced.
Defrost Sensor
Failed defrost temperature sensor.
Causes unit to not defrost properly and
can create large frost build-up. Can lead
to water damage to the unit and sur-
rounding oor.
Unplug the power cord imme-
diately and call service to have
the defrost sensor replaced.