Owner's Manual

Door Reversing Instructions

1. Open door.

2. Loosen screw #1 and #2 using a Philips Screwdriver on top and bottom hinge. Slide door and remove the door from the

unit.

3. Once door is removed, using a Philips Screwdriver remove screws from magnet actuator located on inside and bottom

of door. (On Integrated Models magnet actuator will be located on bottom of door.

Figure 16

Figure 17

Figure 18

4. Remove caps from top of door. Using a Philips Screwdriver, install magnet actuator on opposite side. Install caps into

opposite side.

5. Remove caps from screw holes on opposite side (2 on top and bottom). Using a Philips Screwdriver remove the 4

screws that you previously loosened.

6. Reinstall screws and caps on opposite side.

7. Once screws are partially installed, rotate the door 180°, align the hinge over screw #1 and slide into position. Tighten

screws on top and bottom.

8. Door is now reversed.

DOOR REVERSAL

"V" notches

in bracket