Troubleshooting guide

25
Hinge and Gasket Adjustment
It is possible that doors may become out of adjustment in
shipment.
If product is installed slightly “out of level”, doors may not
line up properly. Check this BEFORE adjusting hinges.
Door gaskets occasionally compress in shipment. If gasket
does not seal all around, warm slightly with a hair dryer
and pull outward softly until magnet in gasket seals against
cabinet.
To expose concealed door hinge screws, remove plug but-
tons if present. All hinge sections attached to doors adjust
left or right. Top and bottom cabinet hinges are also adjust-
able in and out. See Figure 32 (shown without cabinet trim).
Figure 32
NOTE
Loosen door
hinge screws to
adjust door left
and right.
Loosen hinge
screws to ad-
just the door in
and out-
HINGE AND GASKET ADJUSTMENTS
Step 3: Attach the Overlay Panel to the Door
1. Remove the gasket from the door front. (See Figure
31). Do this by pulling the gasket out of the chan-
nel that holds it to the door front. This will expose the
clearance holes for mounting the custom overlay panel.
(See Figure 31).
2. Set the door on the overlay panel and align edges.
(See Figure 31). Clamp panel in position and mark pilot
hole locations. Pick the required pilot hole size from
"Table D" below and drill the pilot holes ensuring not to
drill all the way through the overlay panel.
Table D: Pilot Hole Drill Sizes for Wood Screws
Material Type #10 Wood Screw
Hardwood
9
⁄64" (3.6mm) Diameter
Softwood
1
⁄8" (3.2mm) Diameter
3. Insert wood screws through clearance holes and
tighten to secure overlay panel.
4. Reinstall gasket into channel. Make sure the corners
are fully inserted.
5. Install the door back on the cabinet by reversing the
procedure in Step 1.
-Solid door
Screw-
Door
Gasket-
-Door panel
Figure 31