Getting Started Guide

8
USING YOUR ELECTRONIC CONTROL - MPBD AND MPWD MODELS
Control Function Guide
Function Command Notes
ON/OFF Press and release. Unit will immediately turn ON or OFF.
Adjust Temperature
Press or
zone. Press
and release to adjust the upper
to change to lower zone.
Toggle Between
o
F /
o
C Hold and for 5 seconds. The display will change units.
Leave Interior Light On
Press and release to leave interior light on for
12 hours; press again to deactivate.
After 12 hours, factory default is restored; light will turn on when
door is open.
Hide Display Hold and press .
Display will turn o󰀨 when door is closed. Unit will continue to
operate. Repeat command to turn on display.
Adjust Light Color
Press and hold then press and wait for
UI to ash. Once UI ashes, release and
and use the to scroll through options 0-2.
Option Open Door Closed Door
White White
Blue Blue
White Blue
Light will be set at full intensity when door is open, and 50%
intensity when door is closed.
Enable Sabbath Mode Press and hold for 5 seconds and release.
The
o
F /
o
C symbol will ash briey after 5 seconds. Interior
light and display will go dark and remain so until user resets
mode - unit continues to operate.
Disable Sabbath Mode Press and release. Display and interior light return to normal operation.
Door Alert Notication
When the door is left open for more than 30 minutes:
• A tone will sound for several seconds every minute
• will appear in display
• Close door to silence alert and reset
First Use
Initial startup requires no adjustments. When plugged in, the unit will
begin operating under the factory default settings. If the unit was turned
o󰀨 during installation, simply press and the unit will immediately switch
on. To turn the unit o󰀨, press .
Figure 14
Electronic control
High/Low Temp. Notications
When the compartment temperature exceeds the control setting for an
extended amount of time:
• “HH will appear in display (High Temp)
• “LL” will display (Low Temp)
Contact service dept. for further instructions.
Interior light color indicates zone temperature being set;
Blue = Upper (38
o
- 65
o
)
White = Lower (38
o
- 65
o
)
Note: The set temperature of the lower zone can't be
colder than the set temperature of the upper zone.
Adjusting the set temperature of the upper zone may
cause the lower zone to automatically adjust. The lower
zone cannot be more than 20
o
above the set temperature
of the upper zone.
See table on next page.