GE T TING STARTED QUICK REFERENCE GUIDE M ARVEL UNDERCOUNTER REFRIGERATION MPBV415 MPBV424 MPBD424 MPRE424 MPRF424 MPRI424 MPWC415 MPWC424 MPWD424 MPDR424 MPFZ424 T H E O R I G I N A L R E F R I G E R AT I O N E X P E R T S S I N C E 1 8 9 2
CONTENTS Contents: Important Safety Instructions Safety information ...............................................................2 Unpacking Your Appliance ................................................. 3 Installing your appliance ......................................................4 Electrical ..............................................................................5 Door Reversal .....................................................................6 Installing the anti-tip device ...........
UNPACKING YOUR APPLIANCE ! Warranty Registration WARNING It is important you send in your warranty registration card immediately after taking delivery of your appliance or you can register online at www.marvelrefrigeration.com. EXCESSIVE WEIGHT HAZARD Use two or more people to move product. Failure to do so can result in personal injury. The following information will be required when registering your appliance.
INSTALLING YOUR APPLIANCE Select Location The proper location will ensure peak performance of your appliance. We recommend a location where the unit will be out of direct sunlight and away from heat sources. To ensure your product performs to specifications, the recommended installation location temperature range is from 55 to 100°F (13 to 38°C). Front grille screws Cabinet Clearance Ventilation is required from the bottom front of the appliance. Keep this area open and clear of any obstructions.
ELECTRICAL Electrical Connection A grounded 115 volt, 15 amp dedicated circuit is required. This product is factory equipped with a power supply cord that has a three-pronged, grounded plug. It must be plugged into a mating grounding type receptacle in accordance with the National Electrical Code and applicable local codes and ordinances (see Figure 6). If the circuit does not have a grounding type receptacle, it is the responsibility and obligation of the customer to provide the proper power supply.
DOOR REVERSAL Door Reversing Instructions 1. Open door. 2. Loosen screw #1 and #2 using a Philips Screwdriver on top and bottom hinge. Slide door and remove the door from the unit. Figure 6 3. Once door is removed, using a Philips Screwdriver remove screws from magnet actuator located on inside and bottom of door. (On Integrated Models magnet actuator will be located on bottom of door. Figure 7 Figure 8 4. Remove caps from top of door.
INSTALLING THE ANTI TIP DEVICE Anti-Tip Bracket WARNING ! • ALL APPLIANCES CAN TIP RESULTING IN INJURY. • INSTALL THE ANTI-TIP BRACKET PACKED WITH THE APPLIANCE. • FOLLOW THE INSTRUCTIONS BELOW 211⁄2" (54.6 cm) Leveling Leg Bottom View of Appliance Front of cabinet Anti-Tip Device ! Figure 9 WARNING If your appliance is not located under a counter top (free standing), you must use an anti-tip device installed as per these instructions.
USING YOUR ELECTRONIC CONTROL - MPBD AND MPWD MODELS Figure 14 Electronic control Control Function Guide Function Command Notes ON/OFF Press Unit will immediately turn ON or OFF. and release. Adjust Temperature zone. Press and release to adjust the upper to change to lower zone. Interior light color indicates zone temperature being set; Blue = Upper (38o - 65o) White = Lower (38o - 65o) Note: The set temperature of the lower zone can't be colder than the set temperature of the upper zone.
Dual Zone Temperature Table Note: The temperature of the lower zone cannot be less than the temperature of the upper zone.
Dual Zone Temperature Table Note: The temperature of the lower zone cannot be less than the temperature of the upper zone.
CARE AND CLEANING The following suggestions will minimize the cost of operating your refrigeration appliance. NOTE Temperature displayed reflects actual temperature inside unit. If the temperature displayed is different than selected, the unit is progressing towards the selected temperature. Time to reach set point varies based upon ambient temperature, temperature of product loaded, door openings, etc. Marvel recommends allowing the unit to reach set points before loading.
HOUSEHOLD PRODUCT WARRANTY Marvel Refrigeration (Marvel) Limited Warranty ONE YEAR LIMITED PARTS & LABOR WARRANTY For one year from the date of original purchase, this warranty covers all parts and labor to repair or replace any part of the product that proves to be defective in materials or workmanship. For products installed and used for normal residential use, material cosmetic defects are included in this warranty, with coverage limited to 60 days from the date of original purchase.
www.marvelrefrigeration.com Marvel Refrigeration 1260 E. Van Deinse St. Greenville MI 48838 616.754.5601 41015863 Rev C 11/4/21 All specifications and product designs subject to change without notice. Such revisions do not entitle the buyer to corresponding changes, improvements, additions, replacements or compensation for previously purchased products.
