Owner's Guide

ManualsBrandsMarvel ManualsRefrigeration24 Inch Built-In Dual Zone Wine Cooler with 40 Bottle Capacity, Smooth-Glide Racks, Dual Pane Glass Door, 2-Color LED, and Electronic Controls: Stainless Steel Frame Glass

Remove Fan and Cover

CONVECTION COOLING

This unit is equipped with an advanced convection cooling

system. Convection cooling stabilizes cabinet temperature,

cools product faster and increases energy eciency.

Evaporator Fan

The evaporator fan is responsible for circulating warm air

from the refrigeration zone, past the evaporator and back

into the refrigerated zone.

The evaporator fan is factory set to have a 1 minute delay

at the beginning of a cooling cycle. This delay gives the

evaporator time to cool properly before warm air is passed

over it. The fan will continue to run for an additional 2

minutes at the end of a cooling cycle. Fan delay times can

be modied through the service menu.

Evaporator fan operation is also determined by door switch

state. If the door switch circuit opens, the fan will stop.

When the door switch circuit is closed the fan will either

continue running with the cooling cycle, or if not currently

cooling, the fan will run for 1 minute to circulate air and

clear any condensation that may have appeared on glass

doors and shelves.

Note: If the unit is set to sabbath mode, the evaporator

fan will no longer respond to the state of the door switch.

In order to operate eciently, the evaporator fan blade

and vents should be unobstructed and free of any dust

buildup.

Evaporator Fan Replacement

Should the evaporator fan need to be replaced follow the

steps below.

1. Remove any product from the unit.

2. Remove unit from cabinetry to access rear.

3. Disconnect power to the unit.

4. Remove back panel from unit.

5. Disconnect fan electrical connection at rear of unit.

6. Remove insulating foam from refrigerant line pass-

through hole as needed to gain clearance for fan plug.

7. Remove internal shelving.

8. Remove evaporator cover screws.

9. Grasp evaporator cover, pull forward and up as bottom

of cover is installed behind the front edge of the drain

trough.

10. While pulling the evaporator cover clear of the unit, it

may be necessary to use your free hand to manipulate

the fan plug end through the pass-through hole.

11. Remove the 4 screws mounting the fan shroud to the

evaporator plate.

12. Remove and replace fan. Take special care to properly

route fan wire.

Air Flow