MARVEL WINE CELLAR Installation Operation and Maintenance Instructions Refrigerated Wine Cellar 3SWCE l i f e . l u x u r y. m a r v e l ™.
S TA R T I N G O U T Remove Packaging Your wine cabinet has been packed for shipment with all parts that could be damaged by movement securely fastened. Before using, be sure all packing materials and tape have been removed. Important Keep your carton packaging until your wine cabinet has been thoroughly inspected and found to be in good condition. If there is damage, the packaging will be needed as proof of damage in transit.
I N S TA L L AT I O N Select Location The proper location will ensure peak performance of your appliance. Choose a location where the unit will be out of direct sunlight and away from heat sources. Best performance will be maintained when installed within the following parameters: Ideal Ambient Temperature Range Built-in 65°– 80°F Free-Standing 65°– 90°F Cabinet Clearance Ventilation is required from the bottom front section of the unit. Keep this area open and clear of any obstructions.
O P E R AT I O N figure 3 Start Your Appliance To start your appliance, push and hold for 5 seconds, the “ON/OFF” button located on the display panel. (See figure 3) Upon turning the unit on, the display will read the actual temperature inside of the unit. If the interior temperature is greater than 99°F, the display will flash 99 until the temperature drops to 99°F. Interior Light and Switch The interior light makes it easy to view your wine labels and enhances the display of your collection.
A P P L I A N C E F E AT U R E S Insert Wine Bottles The six roll-out shelves each hold four bottles. See figure 4 for typical wine bottle spacing. Tall bottles should not be loaded on the bottom rack because they may prevent the door from closing. Front Bottles (Necks Facing Rear) Loading Tips and Suggestions Bottom rack(s) may be removed for storing “jug” wines. You may store magnums and other large bottles on any of the racks (except for the top rack) by removing the rack directly above them.
CARE AND CLEANING OF YOUR WINE CELLAR Condenser The condenser tubing inside the cabinet does not require frequent cleaning; however, satisfactory cooling depends on adequate ventilation over the coils. Be sure that nothing obstructs the required air flow openings in front of the cabinet. At least once or twice a year brush or vacuum lint and dirt from the condenser for efficient performance by unscrewing the grille on the bottom front of the cabinet.
TROUBLESHOOTING Before Calling for Service Before calling for service, check the troubleshooting table on this page. This table lists possible problems that you can remedy without difficulty to avoid an unnecessary service call.
O B TA I N I N G S E R V I C E If You Do Need Service If you do need service, contact your dealer or the manufacturer. In any correspondence, refer to the model number and serial number of your unit which is located on the upper left hand side of the wall liner. Retain you proof of purchase. You may want to record these numbers in the space below.
WA R R A N T Y E n t i r e P ro d u c t L i m i t e d O n e Ye a r P a r t s a n d L a b o r Wa rr a n t y Marvel warrants that it will supply all necessary parts and labor to repair or replace in the end user's home or office, any component which proves to be defective in material or workmanship, subject to the condition and exclusions stated below, for a period of one year from the date of purchase by the end user.
w w w. l i f e l u x u r y m a r v e l . c o m Marvel Industries P.O. Box 997 Richmond, IN 47375-0997 800.428.6644 41010349 Rev. B All specifications and product designs subject to change without notice. Such revisions do not entitle the buyer to corresponding changes, improvements additions, replacements or compensation for previously purchased products.
