Manualshelf

User's Manual

ManualsBrandsMarvell Semiconductor ManualsElectronicsIEEE 802.11 2X2 MU-MIMO ac/a/b/g/n Wireless LAN + Bluetooth NGFF Module
12345678910
Marvell Semiconductor, Inc.
- 6 -
5. Start driver installation and DUT testing
Now you can run the following commands to install the driver and firmware and start the Manufacturing bridge
application with the following commands.
On the working direction, use the following commands to put the 88W8997 in MFG mode after power on DUT.
./enable
Bring up the ethernet interface and specify an IP address to the Target platform. This address must match the
IP for the DUT in which the Host XP is expecting.
At this point, the target is ready to receive Labtool commands. On the Windows XP laptop where the Labtool
release was downloaded, go to the folder shown below: